9
HARNESS DESCRIPTION (7-PIN)
PIN # COLOR SIZE CONNECT TO
1 Black
(Ground)
18 AWG Good solid ground, usually on the metal frame of the vehicle
2 Violet
(Tach or
Vacuum)
18 AWG Negative (-) side of coil or tach wire of electronic distributor. If the
vacuum mode is used instead, connect one side of a normally
closed vacuum switch to this wire and the other side to + 12V side
protected by the fuse.
3 Grey (Hood) 18 AWG Hood switch connector. The body of the hood switch should be
grounded to the vehicle via the mounting bracket.
4 White (Ground
out)
18 AWG Can be used for V.A.T.S., ignition sense disable. Sends a ground
signal.
5 Orange
(Brake)
18 AWG Side of brake switch which has + 12V when brake pedal is pressed.
(Ignition may have to be ON, depending on the vehicle)
6 Green 18 AWG Data Out (Not used).
7 Yellow
(Parking
lights)
18 AWG Parking light or switch wire that has + 12V. When parking lights
are ON
HARNESS DESCRIPTION (11-PIN)
8 Brown (Lock) 18 AWG On cars with Negative Trigger door lock systems, this wire can be
attached directly to the wire that locks the doors when a ground is
applied.
9 Green(Unlock) 18 AWG On cars with Negative Trigger door lock systems, this wire can be
attached directly to the wire that unlocks the doors when a ground
is applied.
10 Blue (Trunk) 18 AWG Pin 85 of a relay added for this feature. Sends a GROUND signal.
11 White/Yellow
(Starter Kill)
18 AWG Pin 85 of starter kill Relay (see diagram).
12 White/Black
(-)Door Switch
Input
18 AWG Connect to the car circuit, usually the dome light circuit, which
gives a GROUND when a door is opened. (NOTE: Only one of
the two door switch wires must be connected.)
13 Orange/Black
(+) Door Switch
Input
18 AWG Connect to the car circuit, usually the dome light circuit, that gives
+12V when a door is opened. (NOTE: Only one of the two door
switch wires must be connected.)
14 Yellow (Glow
plug)
18 AWG Used for diesel engines. Connect to (+) when ON side of the OEM
glow-plug (Wait to start)
15 White/Green
(Disarm)
18 AWG Used to disarm factory alarm.
16 Red
(Siren/Horn)
18 AWG + 12V siren output. Connect to the positive side of the siren.
**When used with a factory horn, a relay is required to convert
source to a ground signal.
17 Blue/Black
(Parking Brake)
18 AWG Connect to (-) OEM parking brake wire.
18 White/Brown
(Rearm)
18 AWG Used to rearm factory alarm.
19 AUX 14 AWG (2
nd
Ign/ACC/Crank) (+)
20 Valet Plug in
21 Led Plug in
22 Shock Sensor Plug in
• NOTE: Constant 12 volts wires must be connected to heaviest gauge 12 volt wires at
ignition switch. When there are two constant 12 volt wires at ignition switch wires A and
E must be separated (each to their own 12 volts source). When there is only one 12 volt
source at ignition switch then and only then can they be connected together.
(12 paginas)
(7 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales