Autostart as2520 Guía de instalación descargar pdf (Pagina 5)

Installation Guide P. 5

This wire will power the heater blower motor. Usually connected

to the accessories wire of the vehicle. The source wire must have

power with the ignition key in the IGNITION ON (RUN) position only

(no power in the CRANK position).

E ORANGE

(+) Accessories

output (30 A)

Warning: at the ignition switch of certain vehicles, there may be

more than one ignition wire for powering the heater blower motor.

Use the 5

relay (Pin F) and extra relays to power up any extra

ignition wires if necessary. Do not jump wires at the ignition

switch: this would compromise the OEM electrical system.

This high-current output can be used to power a second ignition,

accessories or crank wire. See jumper setting on page 16, for

correct output.

F GREEN

(+) Fifth Relay

output (30 A)

Please note: additional ignition, accessories, or starter wires must

use external relays. Do not jump wires at the ignition switch: this

would compromise the OEM electrical system.

5-Pin Secondary Harness

Wire Colour Function Description

1 BLACK

(–)

Chassis ground

input

This wire must be connected to bare, unpainted metal (the chassis

or the true body ground). It is preferable to use a factory ground bolt

rather than a self-tapping screw. Screws tend to get loose or

rusted over time and can cause erratic problems.

This wire will allow the module to sense whether the engine is

running. The wire requires at least 1.8 V (AC) and 1.6 Hz or faster

when the engine runs at idle speed. Common references for the

tach wire are: the negative side of the ignition coil, the camshaft

sensor, the crankshaft sensor or the engine control module (ECM).

2 PURPLE

(A.C.)

Tachometer

input

Note: if the tach signal is too low, the module will “over-crank”.

Conversely, if the tach signal is too high, the module will “under-

crank”.

3 GREY

(–) Hood switch

input

Connect this wire to the installed hood pin switch supplied. This

input will disable or shut down the remote starter when the hood is

up.

4 ORANGE

(+) Brake Switch

input

This wire must be connected to the brake light wire of the vehicle.

This wire must have +12 V only when the brake pedal is down. This

input will shut down the remote starter if the brake pedal is pressed.

This wire provides a +12 V output and must be connected on the

vehicle to the parking lights wire that tests +12 V when the light

switch is in the ON position.

5 YELLOW

(+) 12 V Parking

Light output

Note: ensure that the voltage does not decrease or increase when

the dimmer control switch is turned. If the voltage goes up or down,

find another parking light wire.

1 2 3 4 5 6 7 8 9 10 ... 20 21

Comentarios a estos manuales

Sin comentarios

Autostart as2520 Guía de instalación Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Arrancadores remotos Autostart as2520